vent rib dent

[tbob131]

just purchased 1100 special field has a dent in the rib I need a murray's vent rib tool. Wondered if anyone close to e-town might have one.

[quackrstackr]

Why do you need a special tool?

A flat screwdriver with some duct tape on the end of it to protect from scratches will make it look as good as new. Just go slow..

[claynut69]

Two wooden wedges. Start them in from opposite sides and tap with hammer unitl done.

[GunCat]

Two wooden wedges. Start them in from opposite sides and tap with hammer unitl done.

To avoid over stressing the solder joints and possible pulling the rib loose use 2 clamps (padded to avoid scratching the metal) to help secure the rib posts on each side of the dented section before you insert your wedges or screwdriver